cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1268
Views
0
Helpful
5
Replies
mahesh18
Frequent Contributor

Single Interface and two Zero NAT config on 8.2

 

We have ASA running 8.2.

It has NAT 0 for Cisco VPN users  below

 

nat(inside) 0 access_list Zero_NAT----------1

 

When I config new NAT 0 for IPSEC below

nat(inside) 0 access_list Exempt_NAT---------2

 

When I put NAT config line 2 it overwrites the NAT 0 line 1

 

Need to know is this be design?

or I need to do something different?

 

Regards

Mahesh

5 REPLIES 5
mahesh18
Frequent Contributor

Can some one from Cisco answer this please?

mahesh18
Frequent Contributor

Anyone can answer this please?

Sheraz.Salim
VIP Advisor

Hi Mahesh18. you running the old code please consider doing upgrade to 9.x as not many of us know how to configured the old software which is not supported anymore by cisco.

can you try this.

 

nat(inside) 0 access_list Zero_NAT

nat(inside) 1 access_list Exempt_NAT

please do not forget to rate.
mahesh18
Frequent Contributor

will below config do no nat for traffic for inside interface?

As i read only 0 does no nat? 

nat(inside) 1 access_list Exempt_NAT 

my apologies you are right. I have not use a 8.2 image before. can you test this.

 

nat(inside) 0 access_list Zero_NAT

nat(inside) 0 access_list Exempt_NAT

 

if i convert this rule in asa 9.x nat (inside,outside) source static INSIDE INSIDE destination static OUTSIDE OUTSIDE

please do not forget to rate.
Create
Recognize Your Peers
Content for Community-Ad