Single Interface and two Zero NAT config on 8.2

[mahesh18]

We have ASA running 8.2.

It has NAT 0 for Cisco VPN users  below

nat(inside) 0 access_list Zero_NAT----------1

When I config new NAT 0 for IPSEC below

nat(inside) 0 access_list Exempt_NAT---------2

When I put NAT config line 2 it overwrites the NAT 0 line 1

Need to know is this be design?

or I need to do something different?

Regards

Mahesh

[mahesh18]

Can some one from Cisco answer this please?

[mahesh18]

Anyone can answer this please?

[Sheraz.Salim]

Hi Mahesh18. you running the old code please consider doing upgrade to 9.x as not many of us know how to configured the old software which is not supported anymore by cisco.

can you try this.

nat(inside) 0 access_list Zero_NAT

nat(inside) 1 access_list Exempt_NAT

[mahesh18]

will below config do no nat for traffic for inside interface?

As i read only 0 does no nat? 

nat(inside) 1 access_list Exempt_NAT 

[Sheraz.Salim]

my apologies you are right. I have not use a 8.2 image before. can you test this.

nat(inside) 0 access_list Zero_NAT

nat(inside) 0 access_list Exempt_NAT

if i convert this rule in asa 9.x nat (inside,outside) source static INSIDE INSIDE destination static OUTSIDE OUTSIDE