ā08-13-2024 11:43 AM
Can we configure ip sla Monitor object using zone that consists both interfaces i.e isp1 and isp2. Basically my requirement is if one interfaces fails the traffic should divert to secondary isp.
Below link I'm following to do the configuration
https://integratingit.wordpress.com/2020/08/14/ftd-dual-isp-failover/
ā08-13-2024 12:07 PM
Yes sure you can
Check cisco doc
MHM
ā08-13-2024 12:10 PM
I tried but It gives me an error of more than one interfaces in sla monitor. Can you share any document which shows configuring sla monitor object using multiple interfaces in single zone
ā08-13-2024 12:17 PM
Why you need more than one interface in sla monitor?
You can config two monitors
Each monitor have one interface and use for one isp
MHM
ā08-13-2024 12:18 PM
I'm adding an zone which consist of a two interfaces
ā08-13-2024 12:24 PM - edited ā08-14-2024 03:56 AM
MHM
ā08-13-2024 10:20 PM
I mean security zone. I have checked both document and in both they have use/created dedicated zone with respect to isp in sla monitor object.
ā08-14-2024 02:08 PM
Just explain to me what you get from add two interface in one sla monitor' if one down and other up what sla monitor must action here ?
There is no meaning of add two interface in one sla monitor and use this monitor with ISP defualt route.
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide