SNMP monitoring traffic thru L2L tunnel on VPN3000

[markus.ridder]

Hi *,

I am sure this has been asked before, but I could not find it neither in the documentation nor on cisco.com.

How can I monitor the traffic thru a singel L2L tunnel on a VPN 3000 using SNMP ? According to the documentation the tunnels show up as virtual interfaces with indexes of 1000+ , but I can't see any of them neither on the admin web interface nor when I do a 'snmpwalk interfaces' on the box. All I see are the Ethernet interfaces.

Any help is appreciated.

- Markus Ridder

[hadbou]

I feel the following URL will give you a better idea

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_administration_guide_chapter09186a00801050ca.html#xtocid7