software license of ASA5510 to enable Failover

[wangliwei]

     I have two ASA5510. I want to make failover between the two firewalls. However, when I use the command "show version", the display shows that the Failover is disabled. Anyone can help me?

     Here is the output of "show version":

Licensed features for this platform:

Maximum Physical Interfaces         : Unlimited

Maximum VLANs                          : 50       

Inside Hosts                                  : Unlimited

Failover                                         : Disabled

VPN-DES                                     : Enabled  

VPN-3DES-AES                            : Disabled 

Security Contexts                          : 0        

GTP/GPRS                                   : Disabled 

SSL VPN Peers                             : 2        

Total VPN Peers                            : 250      

Shared License                              : Disabled

AnyConnect for Mobile                    : Disabled 

AnyConnect for Cisco VPN Phone  : Disabled 

AnyConnect Essentials                  : Disabled 

Advanced Endpoint Assessment     : Disabled 

UC Phone Proxy Sessions             : 2        

Total UC Proxy Sessions               : 2        

Botnet Traffic Filter                         : Disabled 

This platform has a Base license.

[Julio Carvajal]

Hello Liwei,

Security Plus license is required on both units in order to enable failover,

Check my blog at http:laguiadelnetworking.com for further information.

Cheers,

Julio Carvajal Segura

[wangliwei]

Thank you very much. I will let you know if it works.