10-24-2006 05:26 PM - edited 02-21-2020 01:15 AM
Hi There,
I'm trying to lookup a way to do source-based routing in PIX to achieve the same functionality of the "route-map" command in Cisco routers; is there an equivalent command for it in PIX version 7.x? I recall that this wasn't available in previous versions and I couldn't find this out in version 7.x, too but I wanted to double confirm this with you.
Thanking in advance.
Regards,
Haitham
Solved! Go to Solution.
10-24-2006 08:24 PM
Haitham,
Your understanding is correct, Policy Based Routing is not supported on the Pix Firewall.
Also, dont get confused when you see the "route-map" command option in Pix 6.3 and higher. This command is applicable only when redistributing routes into OSPF.
Pix 6.3 Command Reference:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#wp1017196
Pix 7.2 Command Reference
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/qr_711.htm#wp1648744
Let me know if it helps.
Regards,
Arul
10-24-2006 08:24 PM
Haitham,
Your understanding is correct, Policy Based Routing is not supported on the Pix Firewall.
Also, dont get confused when you see the "route-map" command option in Pix 6.3 and higher. This command is applicable only when redistributing routes into OSPF.
Pix 6.3 Command Reference:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#wp1017196
Pix 7.2 Command Reference
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/qr_711.htm#wp1648744
Let me know if it helps.
Regards,
Arul
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide