ssh or telnet from cisco FTD Cli

[bijay.swain]

how can I use ssh/telnet to connect another device from cisco ftd cli .is this command available on FTD CLI

[Rob Ingram]

@bijay.swain 

You can login to "expert" mode and use the ssh or telnet command.

[bijay.swain]

Hi Rob 
         Thanks for your reply . I tried but from expert mode ii am unable to ping the devices connected to my inside zone. all request is by default going to management port which is not connected to any network. it says no route to the host (hosts are in inside zone).

[Marvin Rhoads · Accepted solution]

To ssh (or telnet) from an FTD device requires using the management interface. The data plane interfaces are not available for those functions.