Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have installed the embedded controller image on C9115AXI-D access point and working fine till it is rebooted. once rebooted it boots in to IOSXE image but no connectivity (no ping no http or https). gig0 interface is up but self ping also fails.I h...
HII have 2 Queries1.How to reset CIsco FTD 1000 series password keeping the configuration as it is.2.If I have the config file of FTD .is there any tool to get the admin password using this config file.
Hi All
Below is the config of a device running RIP
interface Vlan10ip address 10.4.4.40 255.0.0.0!interface Vlan4ip address 192.183.12.1 255.255.254.0 secondaryip address 192.183.74.1 255.255.255.0router ripredistribute connectednetwork 10.0.0.0
My...
ewc#sh ip int briInterface IP-Address OK? Method Status ProtocolGigabitEthernet0 192.168.10.15 YES NVRAM up upewc#ewc#ewc#ping 192.168.10.15Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.10.15, timeout is 2 seconds:.....Succe...
