- Have a 6506-E with two supervisors: Supervisor Engine 720 10GE VS-S720-10G
- The software versions match: both have s72033-advipservicesk9-mz.151-2.SY10.bin
- show redundancy: slot 6 is ACTIVE but slot 6 is STANDBY COLD and operating redundancy mode = rpr Reason: Software mismat
- show mod:
Mod MAC addresses Hw Fw Sw Status
---- ------------------------------- ----- ----------- ------------ ---------
1 0022.554d.2180 to 0022.554d.218f 1.6 12.2(18r)S1 15.1(2)SY10 Ok
2 0022.9010.8a18 to 0022.9010.8a27 1.6 12.2(18r)S1 15.1(2)SY10 Ok
4 001c.5869.9db0 to 001c.5869.9db3 2.2 12.2(18r)S1 15.1(2)SY10 Ok
5 0016.c848.57bc to 0016.c848.57bf 3.1 8.5(3) 15.1(2)SY10 Ok
6 0022.9046.e290 to 0022.9046.e2bf 4.1 8.5(4) 15.1(2)SY10 Ok
- I didn't put in full output due to system being on a different network.
- sh bootvar
BOOT variable = sup-bootdisk:1;bootdisk:s72033-advipservicesk9-mz.151-2.SY10.bin,12;
CONFIG_FILE variable does not exist
BOOTLLDR variable does not exist
Standby Configuration register is 0x2102
Standby is up
Standby has 1048576K/65536K bytes of memory.
Standby BOOT variable = sup-bootdisk:1;sup-bootdisk:/bootdisk:s72033-s72033-advipservicesk9-mz.151-2.SY10.bin,12;s72033-advipservicesk9-mz.151-2.SY10.bin
- If more information is needed please let me know.
Best Regards,
Seth
