I have a requirment to allow a vendor access to a lot of devices on a subinter face DMZ which I created just for their devices.
However I only have one public address left to allow access from the outside.
They need specific udp and tcp ports open depending on which device they are accessing. I created object-group service config for all the ports but not sure how to actually allow the outside access into the DMZ.
device 192.168.13.6 needs access both ways on udp ports 18810,18803,18801 and 18001. And this same device needs access both ways on tcp port18802.
And device 192.168.13.2 needs another set of udp and tcp ports open.
All of the devices have variations like this.
What is the correct static nat config to allow the vendor access from outside to many addr in this DMZ?
IntroductionFeatured AuthorLive QuestionsQ: In your opinion is it feasible to go straight and attempt the CCIE Security before getting CCNP Sec?Q: Does this book cover security contents with new Cisco CCIE exam changing in February 2020?Q: Do we have an o...
Securing What's Now and What's Next. With our annual global survey of 2,800 security leaders, we dove deep to compile key benchmark statistics. The 2020 CISO Benchmark Report provides valuable takeaways and data on the most pressing cybersecurity to...
I have 2 Firepower module (ASA 5525) with Malware and IPS licence. Recently i changed the Malware policy action set to "Block Malware" and "Reset Connection". How to log the event if my policy blocked any files? Please find the attached screen shot f...
Hi, We have ISE v2.4 installed in production for only 2 month now. we are integrating anyconnect for posturing on all end users machine. I want to get the report or statistics of all the machines on which anyconnect client is installed.
SecureX connects the breadth of Cisco’s integrated security portfolio and your entire security infrastructure for a consistent experience that unifies visibility, enables automation, and strengthens your security across network, endpoint, cloud, and appl...