static translation for many

[tsrader]

ASA5520 being used as isolation device only.

Groups wants multiple statics translations setup to allow access from inside to outside via RDP......is there a way to do "auto" static translation for many ip addresses? or do i need to enter each static translation by hand?

192.168.1.1 > 10.168.1.1

192.168.1.2 > 10.168.1.2

etc

etc

192.168.1.254 > 10.168.1.254

[armeskarreg]

You can write only one static, like this :

static (outside,inside) 192.168.0.0 10.168.0.0 netmask 255.255.0.0 0 0

[pengfang · Accepted solution]

Cisco not support IP Shift NAT, see the thread below:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Firewalling&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc01de1

Netscreen can do this.

[pengfang]

Glad it was helpful, thanks for rating.