Tried to post in SBCS session but no luck.Hi All,I got some issues for one of my customer. The UC520 is running CME v8.0, uc500-advipservicesk9-mz.150-1.XA and phone load v8.5.3, CCA 2.21. Once I setup a blast group call with 2 members - no answer fo...
Hi,I'm currently evaluating the NGS latest v2.01 image with a fresh new installation. After initial installation, I created sponsor and guest account.My plan is to use a Cisco ASA as the Radius client with Cut-through authentication - Radius to simul...
Hi all,I couldn't find any details how to use RADIUS Vendor-Specific Attributes (VSA)26 , cisco av-pair but only some samples like: cisco-avpair= "shell:priv-lvl=15" Is there a FULL list of these attributes with correct syntax explained for IOS 12.4 ...
Hi guys,I have a hunt pilot with 5 members, how can I repeat the hunting if all members no answer or busy until Maximum Hunt Timer timeout. it seems each member only hunted once by defaultMy CCM version is 4.1Thanks
Hi guys, is there any way I can control users to access the phone service like extention mobility based on time of day ? for example, after hours, new user can't login and existing user was forced to logout ?Thanks,Peng
Hi I got same issue using distance command in EIGRP for external redistributed routes,it dosen't work.. I would LabR1(192.168.0.3) prefer the D EX routes coming from 192.168.0.1. The IOS is 12.1(3r)T2.interface FastEthernet0/0 ip address 192.168.0.3 ...
Thanks Udit, since I don't have the box to test, can you verify my assumption below ? As long as the timeout in blast group less than CFNA timeout in the ephone-dn, the call should hunt the "final" dn once group members no answer?Here's my example:cm...
Hi Tim/Dan,I like the new site, here's my two cents:1. It would be nice if we can select default pre-defined "Items per page" from Account -> Preference or Your View (personalize), it looks by default is 30 items every time you enter a new section o...
Thanks for reply. The problem is there're no any explanations how to use these attributes, such as these attributes belong to what "service", "value" and what application applied for.
Hi Raghu and Ziad,I couldn't find any details how to use RADIUS Vendor-Specific Attributes (VSA)26 , cisco av-pair but only some samples like:cisco-avpair= "shell:priv-lvl=15"Is there a FULL list of these attributes with correct syntax explained for ...
