storage device not found

[seckka21]

Hello 

i have an ASA 5525-x.I am reimaging it by installing firepower sfr 6.2.2.The ASA verion is 9.8.but after the command sw-module module sfr recover boot.i have this error:storage device not found.install driver and try again.

in these image we have the  command show sfr module and show inventory.

[Marvin Rhoads]

The ASA 5525-X requires an optional SSD to run the Firepower service module. Without that, you cannot install the module.

[seckka21]

Hi Dear

Now i have another ASA with an optional SSD .The version is 9.8 and i am reimaging firepower with version 6.2.2.3 but after the command sw-module module sfr recover boot the module is still recovery status.

Here are the version and detail about module.Please really need your help

[Marvin Rhoads]

Once you've done the "recover boot" you need to session into the module and complete the setup as described in this document:

https://www.cisco.com/c/en/us/support/docs/security/asa-firepower-services/118644-configure-firepower-00.html#anc8

It will only move into operational state once the system image (vs. boot image) is installed and configured.

[seckka21]

when execute the session sfr console  command i have the following output:

ciscoasa(config)# session sfr
Opening command session with module sfr.
Module sfr did not respond to session request.