03-21-2006 01:03 PM - edited 02-21-2020 12:47 AM
Is this a supported HW configuration? It isn't listed
as such in the install manual. I'm guessing that the
2 built-in interfaces aren't listed in that table
in the install manual, just the interfaces that can
be added via the PCI slots.
Peter
03-22-2006 01:13 AM
Hi,
Check the list of options for number of interfaces you can use on pix-525.It will depend on the License you have in pix.
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/hig63/525.htm#wp1040963
Hope this helps.
Tanveer
03-23-2006 10:15 AM
Actually your link points to the same table I
referenced in my earlier post. My interpretation
of this table is that it shows the possible
combinations of interfaces that can be installed
using the 3 PCI slots, and doesn't include the
2 built-in FE interfaces.
I tested this by installing 3GE PCI cards, and all
the interfaces (3GE + 2FE) are recognized by the OS,
so I'm assuming that this is a supported configuration.
thanks,
Peter
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide