Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After trying to activate a zoneset we keep seeing the following log messages endlessly repeating:2012 May 4 02:01:45 mds209017901-f1 %ZONE-2-ZS_CHANGE_ACA_FAILED: %$VSAN 265%$ ACA failed : domain 0x63 returns FABRIC_CHANGING2012 May 4 02:01:45 mds2...
We have a FWSM in a Cat6500(12.2(33)SXI). We use AAA tacacs with local failover for ssh access to both the FWSM admin context and the switch. Works great. However when trying to session to the FWSM from the switch it only seems to allow 1st level acc...
I'm trying to get device support for our new blade switches in Cisco LMS. I've installed the package CBS31x0(2.0), and it seems that CiscoView can correctly deal with the switches. However when I attempt to test the credentials, I get something like ...
I know that this was supposed to be fixed in 3.1, but I can't seem to get anyresults when running standard capture commands on any interface even though I'm sure traffic is flowing. This is a FWSM in a Cat 6500, running IOS 12.2(18)in multiple contex...
I have been trying to fix a really annoying ssh timeout setting of 1 minute but haven't had any luck. Here are the relevant commands:mgmt-firewall# sh run sshssh infra-mgmt_subnet 255.255.252.0 infra-mgmtssh timeout 60ssh version 2mgmt-firewall# sh ...
OK here are the outputs from "show zone internal vsan 265" from both switches (domain 6 & domain 99)domain6:mds209017901-f1# show zone internal vsan 265VSAN: 265 default-zone: deny(rw) distribute: full E_D_TOV: 2000 R_A_TOV: 10000 D_S_TOV: 5000 ...
I am not sure how to gather all the requested info regarding # switches in fabric, ivr version etc. I can include the output of show ivr tech if that would be helpful. I "believe" that there are only 2 switches actively participating in the IVR. mds...
One thought that may or may not be useful depending upon your environment. I only have my "aaa authentication match" acl permit https traffic to the firewall itself. I then use radius-based per-user downloaded acls to enable the appropriate network a...
Don't have any brilliant suggestions for your problem, but thanks you helped me solve a problem I've been having. How did you ever discover the URL for the web auth service? I built something similar with PIX 8.0 and had everything configured correct...
