Re: The command to clear the hitcount on the pix firewall

amashau · ‎08-23-2004

Does Cisco have the command to reset or clear the hitcount to start at zero on the pix firewall except to reload the pix.

I hope you will be able to help.

Thanks

HEATH FREEL · ‎08-23-2004

I do not beleive it does, however you can remove the ACL/Conduit entry and then put it back it. It is not very effective but it is better than a reload.

sachin · ‎08-23-2004

If you are using PIX 6.3 version then command available is " clear access-list counters ". Just check whether this command is there in you firewall or not.