ā03-29-2020 11:07 PM
Hi Guys,
I am configuring a Firepower service module using the ASDM and I am using FP 6.4 version. I noticed that I cannot change the timezone of my Firepower module using the ASDM as it is default in "New York". Do you have any workaround for this issue?
Thanks
ā03-30-2020 01:24 PM
You could try the following work-around. I unfortunately do not have an ASA with firepower module to test on at the moment.
Workaround:
Change the System Policy->Time Synchronization setting to manual mode, deploy the new System Policy, then set the timezone in the Local->Configuration->Time settings. Then, go back to your System Policy and change back to NTP mode (you'll have to re-enter your NTP server info) and deploy the new System Policy.
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuu10347/?rfs=iqvred
ā03-31-2020 06:11 AM
Hi @Marius Gunnerud, I tried that multiple times already and I even tried to re-image the module but when I change the time to manual, I cannot see the change time-zone option which is a bit weird.
Have any idea?
Thanks
ā03-31-2020 06:55 AM
Have a look at the solution here, might be a possible solution.
https://www.petenetlive.com/KB/Article/0001363
ā04-02-2020 09:26 PM
Hi @Marius Gunnerud , I tried this way as well but with no luck.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide