06-14-2011 09:31 AM - edited 02-21-2020 04:22 AM
We have two 5510s, running v8.2(2). On the "Firewall Dashboard", in the "Top Usage Statistice" window, I can see the "Top 10 Services", but both the "Top 10 Sources" and the "Top 10 Destinations" tell me "No ata available to display." How do I activate this capability?
Solved! Go to Solution.
06-14-2011 01:40 PM
Hello,
Each of these features (especially the Top 10 Services) uses a good bit of RAM. If you are running a 5510 or smaller, that can cause you to run out of RAM.
To enable using the ASDM:
Configuration > Firewall > Threat Detection > Scanning Threat Statistics
Host = Top 10 Sources / Destination
Access Rules = Top 10 Access Rules
Port / Protocol = Top 10 Services
Regards,
Sooraj
P.S.: please mark this thread as answered if you feel your query is resolved. Do rate helpful posts.
06-14-2011 01:40 PM
Hello,
Each of these features (especially the Top 10 Services) uses a good bit of RAM. If you are running a 5510 or smaller, that can cause you to run out of RAM.
To enable using the ASDM:
Configuration > Firewall > Threat Detection > Scanning Threat Statistics
Host = Top 10 Sources / Destination
Access Rules = Top 10 Access Rules
Port / Protocol = Top 10 Services
Regards,
Sooraj
P.S.: please mark this thread as answered if you feel your query is resolved. Do rate helpful posts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: