06-14-2011 09:31 AM - edited 02-21-2020 04:22 AM
We have two 5510s, running v8.2(2). On the "Firewall Dashboard", in the "Top Usage Statistice" window, I can see the "Top 10 Services", but both the "Top 10 Sources" and the "Top 10 Destinations" tell me "No ata available to display." How do I activate this capability?
Solved! Go to Solution.
06-14-2011 01:40 PM
Hello,
Each of these features (especially the Top 10 Services) uses a good bit of RAM. If you are running a 5510 or smaller, that can cause you to run out of RAM.
To enable using the ASDM:
Configuration > Firewall > Threat Detection > Scanning Threat Statistics
Host = Top 10 Sources / Destination
Access Rules = Top 10 Access Rules
Port / Protocol = Top 10 Services
Regards,
Sooraj
P.S.: please mark this thread as answered if you feel your query is resolved. Do rate helpful posts.
06-14-2011 01:40 PM
Hello,
Each of these features (especially the Top 10 Services) uses a good bit of RAM. If you are running a 5510 or smaller, that can cause you to run out of RAM.
To enable using the ASDM:
Configuration > Firewall > Threat Detection > Scanning Threat Statistics
Host = Top 10 Sources / Destination
Access Rules = Top 10 Access Rules
Port / Protocol = Top 10 Services
Regards,
Sooraj
P.S.: please mark this thread as answered if you feel your query is resolved. Do rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide