06-14-2011 12:41 AM - edited 03-11-2019 01:44 PM
Hello,
I would like to translate a matching destination IP Address from a specific source network to a specific destination IP Address.
Is this possible to be done on Cisco IOS Router?
06-14-2011 01:23 AM
Hello,
Could be a little more clear on your question please.
You can refer to the below mentioned document to configure NAT on IOS
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml
Regards,
Sooraj
P.S.: please mark this thread as answered if you feel your query is resolved. Do rate helpful posts.
06-14-2011 07:45 AM
Yes and it is easy.
As a NAT source you can use extended access list:
ip access-list exte NATDST
permit ip SOURCE_IP SOURCE_WILDCARD DESTINATION_IP DESTIONATION_WILDCARD
ip nat inside source list NATDST pool WHICHEVERYOUDEFINED
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide