type of PIX to determine

johnleeee · ‎08-16-2004

Hi all,

could someone help me how can I determine

type of PIX and value of Flash.

This PIX has floppy drive. So I closed ring

to PIX classic, 10000, 510 and 520.

PIX ver. of IOS is 4.2.3.

And other question is how to determine value of flash.?

It has 8MB of RAM.

sh ver is:

PIX# sh ver

PIX Version 4.2(3)

Compiled on Tue 08-Dec-98 19:44 by pixbuild

PIX up 25 mins 27 secs

Hardware: Pentium 133, 8 MB RAM, CPU Pentium 133 MHz

Flash atmel @ base 0x300

0: token-ring0: address is 0000.832d.48cb, irq 10

1: token-ring1: address is 0000.832d.4871, irq 11

reg

jl

scoclayton · ‎08-16-2004

This is a PIX "classic" with 2 MB of flash. Been a while since I have seen token-ring interfaces on a PIX...very impressive ;)

Scott

johnleeee · ‎08-16-2004

Hi Scott,

could you give me advice how you determined type

and value of Flash please.?

thanks a lot jl

scoclayton · ‎08-17-2004

What, you don't trust me? ;)

Only kidding, I wouldn't trust me either normally but this time, I am pretty sure I am right. You can verify this information here:

(look for the question, "Q. How do I determine how much Flash memory my PIX has?")

Hope this helps.

Scott

johnleeee · ‎08-18-2004

Hi guy,

I trust you of course, but I wanted to know

closer informations not only answer.

In our newer PIXs its better to recognize Flash because it can be wieved trough sh ver comm.

So thanks very much for advice

reg

jl