UID PID/ UID Serial Num of a Virtual Firepower Management Centre

[stacson]

Hi,

I've installed 2 software versions of the virtual management centre in our lab and the next step is to install eval licences. I need to get the UDI Product ID & UDI Serial Number but I'm not sure how to go about this.

These are the files I have had installed on VMware

• FireSIGHT Virtual Defense Center for VMware - Sourcefire_Defense_Center_Virtual64_VMware-5.4.0-763.tar.gz
• Firepower Management Center Virtual64 VMWare  -
  Cisco_Firepower_Management_Center_VMware-6.2.0-362.tar.gz

Can anyone help?

[GRANT3779]

Hi,

A smilar question was asked not too long ago which may help -

https://supportforums.cisco.com/t5/security-and-network-management/prime-firepower-serial-number/td-p/3095435#comment-12201106

Thanks

[stacson]

Thanks for that. I did a search before posting but didn't find this thread. If our lab had internet access this would be helpful, but we don't - I must use the Cisco website to get an eval licence. It requires the UID information to get this which I still don't have.

[GRANT3779]

Hi Stacson,

I am not sure then about this. I think you may need to get your Cisco SE involved, unless someone else can point you in the right direction.