241
Views
0
Helpful
1
Replies
unable to go in enable mode in ASA CLI
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2025 03:39 AM
Hi all,
I am facing a issue on cisco ASA firewall where i am able to login Firewall via SSH and able to login firewall but while i am putting the command enable after enter USER and Password, Its declined. i am using the same credentials for login the firewall but i am unble to enter in enable mode via same credentials. I have checked via ASDM, Account has full access. See below.
/pri/act> enable
Password: ********
Invalid password
Password:
Please suggest here a solution.
Thanks
Yogendra Singh
Labels:
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2025 05:35 AM
Only press enter and check
Also share the config
MHM
