Has anyone experienced configuring the FMC gui to be reachable and can be accessed from other locations and can register the FTD 2? the type of connection is via MPLS.
Forum Posts
Hello guys,we try to access a firepower 1010 (remote office) from our headquater over an ipsec tunnel via ssh.Therefore we configured a loopback interface, which is part of the routing over the vpn, and this loopback is pingeable.Somehow we are not a...
Greetings Everyone, im new with cisco Firewall Management Center. we had an issue with monitoring widget not displaying (buffering) on Summary Dashboard Network tab. We already searching to troubleshoot this issue, some of the tshoot that we applied ...
I am having a difficult time copying files to and from a local tftp server with an ASA. I want to plug my laptop running the tftp server directly into the ASA on one of it's ethernet ports and copy files but I can't seem to get the laptop and ASA to...
We were able to register our 2 new devices. When we try to configure HA we run into a registration issue. Registration unknown. I did register with different Mgmt IPs in order to reach the internet. I now changed the IPs back to what we need. We need...
We have several deployments failing when there is a new LSP update on the FMC that gets pushed to the FTDs. It seems like the file copy jus stalls out anywhere between 10-90%. From the /ngfw/var/log/messages i see the following repeating until it tim...
Here’s the situation. I have a Cisco FPR 1010 with FTD, managed via FMC, both running version 7.4.2. I need to set up AnyConnect with authentication via RADIUS. I managed to get AnyConnect up without issues, but there’s a problem with ISE: FTD cannot...
I am looking for an official Cisco document that clearly describes the supported and recommended steps to disable TLS 1.0 and TLS 1.1 on Cisco ASA. I am aware that this can be achieved by setting the minimum TLS version using commands such as: ssl se...
Hi Team,I am using Cisco Firepower Management Center (FMC – Virtual).While configuring System → Configuration → Access List, I mistakenly removed the default entries allowing: any(443) any(22)and added a specific source IP instead.After applying the ...
I want to migrate ASA 5515 to FTD2120, and I downloaded the Migration tools from Cisco version 7.7, but I have an issue as shown in the image below, after signing in using CCO, I tried with different computer same issue
Can anyone have a document or guide describe making a dial up vpn between forrigate as a hub and cisco ftd managed by fmc as spoke ?
I upgraded my FTDv to version 7.6.2 and when i try deploying policy, it failed with this error: error : ERROR: cannot set np to promiscuous mode.ERROR: Failed to initialize interface, Add interface Failed. Has anyone seen this and any workaround?Tha...
I'm considering a design change where I consolidate two WAN circuits behind shared edge hardware in order to better leverage some existing hardware. The environments are currently structured as:- 2 ISPs- 2 firewalls- 1 Layer-3 Switch- 3 access Switch...
I have a requirement of capturing the login banner details which is one of the requirements of the baseline compliance i am working on. I configured a custom pre-login banner from FMC GUI successfully and I am able to see the custom banner but if I t...
Resolved! Cisco FTD Evaluation Mode
Hello Team, I am testing a Cisco Firepower 1010 physical appliance running FTD 7.2.5 in standalone mode. The device is currently in Evaluation mode (no licenses applied). Observed behavior: Internet traffic works when allowed in Access Control. Inter...
