Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
266
Views
0
Helpful
1
Replies

Unable to Inirtialize PIX MC Database

infinitingr2
Level 1
Level 1

‎07-29-2004 03:44 PM - edited ‎02-20-2020 11:32 PM

I was at the last stage (99%) of installing Firewall MC 1-3-2 w2k when I gor this message: "Unable to Initialize PIX MC Database" This message came on about 6 of 7 times, and finally I got the message that the installation was complete. Has anyone run into the same problem and what was the cause and the solution.The VMS on which I was attempting to install firewall MC is up to rev and I am actually using it for IDS Mgt.

Would appreciate any suggestion.

Ade

0 Helpful
1 Reply 1

nkhawaja
Cisco Employee
Cisco Employee

‎07-29-2004 08:56 PM

I suggested earlier, check if terminal Services were installed during PIXMC installation. Also if there is any additional services you see running e.g. any PC related services, disable them. then try to initialize . While you install PIX, select the option to initialize the DB

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card