Buy or Renew
Buy or Renew
NOTICE: You can now engage in the community. Learn about the great new Cisco Umbrella content.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
298
Views
0
Helpful
1
Replies

Upgrade question

qbakies11
Level 1
Level 1

‎12-12-2007 12:30 PM - edited ‎03-10-2019 03:54 AM

I just purchased an ASA with SSM-10 IPS module and am doing the initial configuration. The SSM has IPS v5.1(6)E1 installed on it and I wanted to know if I should upgrade it to the new IPS v6 before configuring and putting it into production. If so can someone give me a link to the instructions for upgrading? Thanks in advance!

Labels:
0 Helpful
1 Reply 1

rmaxson2
Level 1
Level 1

‎12-17-2007 06:23 AM

Same here. Went to config the IPS and the ASDM does not support 5.1(5)E1 and says to use 6.0.1 or above. Can't find a 6.0 for ASA is it available?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card