- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-14-2010 08:15 AM - edited 03-10-2019 05:03 AM
Hi guys:
Does anybody know the process to update the signature version on a CISCO IPS, i want to do this manually. If somedoy can tell me the commands and all I need to make this.
Regards
Solved! Go to Solution.
- Labels:
-
IPS and IDS
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-14-2010 12:10 PM
Luis;
Manual signature updats for Cisco IPS sensors can be performed from the CLI as outlined here:
Or from the IDM GUI as outlined here:
This same process is also used to upgrade the sensor's base software.
Scott

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-14-2010 12:10 PM
Luis;
Manual signature updats for Cisco IPS sensors can be performed from the CLI as outlined here:
Or from the IDM GUI as outlined here:
This same process is also used to upgrade the sensor's base software.
Scott
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-15-2010 09:04 AM
Thanks Scott, that information was really helpful.
Have a nice day.
Saludos
