12-17-2008 07:28 AM - edited 03-11-2019 07:27 AM
I am new to cisco and have a question about upgrading the ASA and ASDM. We have a new 5510 that shiped with ASA 7.0(8) and ASDM 5.0(8). I have uploaded ASA 7.2(4) and ASDM 5.2(4) via the Gui but how do I get it to load the new .BIN files?
Thanks
Solved! Go to Solution.
12-17-2008 07:40 AM
boot system flash:asa802-k8.bin
You'll want your image name of course. For ASDM-
asdm image disk0:/asdm-602.bin
Again change the line to match the ASDM image file name.
Hope that helps.
12-17-2008 07:40 AM
boot system flash:asa802-k8.bin
You'll want your image name of course. For ASDM-
asdm image disk0:/asdm-602.bin
Again change the line to match the ASDM image file name.
Hope that helps.
12-17-2008 08:04 AM
That worked But I had to run the boot system flash then reboot and then run the asdm image. Other wise it was giving me un reconized image file.
Thank you very much.
12-22-2010 10:05 AM
Previously I uploaded asa802.k8.bin and asdm-602.bin to the asa5505 in disk0:
I was running asa7.2(4) and asdm 5.2(4).
I used asa 7.2(4) and upgraded to asa802-k8.bin using the asdm 5.2(4) interface. After the reboot I could not use the asdm because of the software mismatch. I hooked up my console connection and tried to issue
asdm image disk0:/asdm-602.bin
to update the asdm but I get an error 'invalid input' with the caret pointing to the 'i' in image.
Everything I read says this is the way to do it but the asa does not seem to like the command.
Has the command changed in 802 or am i missing something?
JoeDanieli
12-22-2010 11:01 AM
Fixed my problem. Since I only deal with the asa when I have problems I forgot the config terminal command.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide