I have a ASA 5506-x v4 and im wondering if I can use the firepower management center to manager the firepower sensor on the ASA. When I go to the IP address of firepower I get this message: (I dont have a active service sontract as this is just for home use). I have tried to download the FMC (Firepower Management Center) but I need a service contract.
Accepted Solutions
.jpg "VIP Advisor"){kind=icon}
5506-x sfr sensor can managed through ASDM or vFMC/FMC. In order for you to manage the 5506-x sfr module from vFMC. you need to download the vFMC appliance than you have to register your 5506-x sensor to vFMC. yes to get download the vFMC you need a active service contract or you could reach to your local cisco representative. however, again in order to have a TAMC (control/protection/url/malware) you need to have a license (or you need to buy lic) for it.
if 5506-x is a new out of box it will give you 90 day evaluation period bear in mind you need a PAK file though.
on site note 5506-x is gone EOL.
5506-x sfr sensor can managed through ASDM or vFMC/FMC. In order for you to manage the 5506-x sfr module from vFMC. you need to download the vFMC appliance than you have to register your 5506-x sensor to vFMC. yes to get download the vFMC you need a active service contract or you could reach to your local cisco representative. however, again in order to have a TAMC (control/protection/url/malware) you need to have a license (or you need to buy lic) for it.
if 5506-x is a new out of box it will give you 90 day evaluation period bear in mind you need a PAK file though.
on site note 5506-x is gone EOL.
