Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to create a span/mirror port on the Firepower 1010 device using the FMC console? I am using the firewall in routed mode but want all the network traffic to be mirrored on one port so I can do some traffic analysis with the security on...
I have a firepower 1010 being managed by the FMC with only the base license. How do I verify that the IPDS is actually inspecting traffic on my various networks? The firewall is in routed mode. Do I need the threat license for it to work?
I have a firepower 1010 with port 0/8 split into 2 sub interfaces/vlans that go to a ubiquit ac access point for 2 wireless networks.This setup works BUT i want to use my switch to pass this vlan traffic.I want to have a port on the firewall that car...
I have a simple setup:Firepower Management Center is managing 1 Firepower 1010 device. I want to know if there is a way in the event of a power loss on the device can the FMC initiate a shutdown to prevent bricking the device from a hard shutdown? M...
I have a situation where I need to update the anyconnect client on 1000 remote users. I am not finding an easy way to do this because the only way to push the new client requires the the computers to be connected to the VPN and if we push the client...
I was thinking that the firewall would be the one sending ALL the traffic to the passive port. From there I would connect from the firewall "Span" port >>>>to the computer's 2nd network interface I was going to use for analysis.
I tried to make one port passive but I didnt see any traffic on it. I have 5 routed networks on the firepower device. I have the passive port connected to an esxi server.
If the firewall is not a switch... why can I create 2 sub-interface's/VLAN's on the firewalls interface and pass both vlans directly into the Ubiquiti access point and it work fine?
Marvin, as always, thanks for your help:)Its just a SOHO setup/lab so Ill go with kepping a good backup and the UPS will help if im there when the power goes out.
