Using FlexConfig to change default command (no sysopt noproxyarp) rule

[KMNRuser]

Community,

We are trying to change a default behavior on an FPR 1010 platform.  the interface in question has the command "no sysopt noproxyarp" configured on it.  We are trying to understand how we can use a Flexconfig in FMC to change this behavior so that it does not proxy arp back to the host in question..  How can we change the behavior to turn off the proxyarp feature on the interface?

Sincerely,

KMNRuser

[KMNRuser]

I have found this within the FMC Interface.. I am just not sure how to adjust it to turn off the Proxy Arp feature..

[Aref Alsouqi · Accepted solution]

Please take a look at this link:

FTD FlexConfig (lookingpoint.com)