ASA is 5540 w/8.3. I have a large inside block of inside address I want to NAT or PAT
to outside addresses. Is it possible to use a block of outside addresses with NAT with
rollover PAT to the whole range, or is it restricted to roll over to only a single address?
Are you looking to do this for outbound connections to the internet? If so, this is possible to do a nat to a group of IP address and then if that gets all used up, have it roll over to a single IP address for PAT.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: