Using NAT and PAT together?

[rwiechman]

ASA is 5540 w/8.3. I have a large inside block of inside address I want to NAT or PAT

to outside addresses.  Is it possible to use a block of outside addresses with NAT with

rollover PAT to the whole range, or is it restricted to roll over to only a single address?

Thanks, Roger

[deyster94]

Are you looking to do this for outbound connections to the internet?  If so, this is possible to do a nat to a group of IP address and then if that gets all used up, have it roll over to a single IP address for PAT.