Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I built a new PI 2.1 (OVF) and imported the config from the running 1.3 instance. Everything is fine except that the tftp server refuses to work. It will not serve files, nor can I put file in it. All of our WLC backups are failing. Using a tftp cli...
I have an inside network using PAT to one outside address. Our DNS server is on anotherlocal, but outside address. I can't get the inside network to successfully get addresses.I have another inside address that just uses the wirewall and gets addres...
ASA is 5540 w/8.3. I have a large inside block of inside address I want to NAT or PATto outside addresses. Is it possible to use a block of outside addresses with NAT withrollover PAT to the whole range, or is it restricted to roll over to only a si...
I have a current ASA (5540, 8.3(2)) that is running in routedmode, doing a VPN endpoint as well as a wirewall for anotherinside network. They use the single public IP addressthat is on the outside interface, which carries thedefault route.I want to ...
I have a routed firewall configuration that requires folks on Inside network to be able to useIPsec VPN which terminates both at the shared public interface and also other end points.I can't seem to set the ASA to allow it. I've added a low security...
Philip,Your plan will work fine. You can export the existing config and import into the new instance.Use license manager to transfer existing license(s) to the new server.Actually, you can run them both simultaneously, but it doubles the load on the ...
Is this maybe 6.1.2 specific? My MAC table is full because of these.It is now refusing to add new entries.This on a pair of N7004sL2 Forwarding Resources------------------------- L2 entries: Module inst total used mcast ucast lines lin...
Sorry, I accidently slipped in DNS. The issue was solely DHCP.I have solved the issue, however. The core router had a static routethat was still pointing at a different ASA, which was deflecting theDHCP response incorrectly.Roger
Anu, Thanks. I think you answered my question, even though I may not have been clear.I had similar issues (in my head anyway) when I was setting up the vpn terminus.It seems like I don't need an outside interface for the traffic at all. It will jus...
