vASA, are subinterfaces supported ?

[simon.bingham]

Simple one, 
I'm configuring a vASA for the first time ever !! and not really a cisco Engineer to conduct a quick bit of Lab work between a Cisco and Juniper SRX ( vpn issues ) .
I can create a interface on the inside of the ASA and ping it, but if I create sub interfaces ( as i want to simulate a few customer networks ) nothing works 

interface GigabitEthernet0/1
nameif Inside
security-level 100
no ip address
!
interface GigabitEthernet0/1.1
vlan 1
no nameif
security-level 100
ip address 172.21.211.126 255.255.255.128

the interface does not seem to work at all, wireshark confirms no packets are sent. 

This is being simulated in Eve-ng, my SRXs work fine like this. 
My vASA has no licence yet

Thanks

Simon

[Rob Ingram · Accepted solution]

Hi,

Define the nameif under the sub interface.

You don’t need a license, you should be able to test all features, but throughput will be limited.

HTH

[simon.bingham · Accepted solution]

Wow thats all it was, thankyou