VMS MC 2.0.2 - Sensor contain no sensing interface

[melangnghe]

We are running VMS MC 2.0.2 for all IDS. While trying to Deploy a job in VMS Management Center for IDS Sensors, we received the following error:

"Generate failed. The configuration of Sensor xxxxx does not contain any sensing interfaces. The configuration should contain at least one sensing interface so that the sensor can obtain packets for analysis."

Can't understand what caused this problem as it is our active sensor with one sensing and one mgmt interfaces.

Your help is much appreciated.

TIA

Simone.

[didyap]

An interface group provides a way to group sensing interfaces into one logical virtual sensor. Only one interface group, 0, is supported. Depending on the configuration of your sensor, you may need to assign the sensing interface to interface group 0 and enable the interface.

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids10/hwguide/hwclipr.htm#wp86441

[melangnghe]

The interface has already been assigned to Group 0, This sensor is still active and still sniffing traffic. It is VMS MC that is complaining.

Your help is appreciated.