VPN Configuration Management & CW2k

thethmon · ‎02-20-2003

I have CiscoWorks 2000 LMS / RWAN with the VPN Monitor software loaded. Currently I have our VPN 3000 concentrators entered in RME with only an SNMP Read-Only string. If I add a telnet access into RME for the VPN concentrator will it pull a copy of the configuration and store it?

rmushtaq · ‎02-20-2003

RME 3.4 does not support Configuration Management for VPN Concentrators per: http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/cw2000e/e_3_x/3_4/dev_sup/e3_4.htm#86401

thethmon · ‎02-20-2003

OK, so what purpose does the Configuration Management section under Reports on VPN Monitor serve? Does this only handle IOS Routers and not the Concentrators? As VPN Monitor requires RME, I was assuming that the Configuration Management pieces were tied together.

rmushtaq · ‎02-20-2003

I believe that you're referring to 'VPN Security Management Solution ' folder in RME?

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/cw2000e/e_3_x/3_4/u_guide/ug_vpn.htm

If so, then due CSCdt01490 it will not show the VPN Concentrators. What I was referring to earlier was the Configuration Archive feature in RME listed as not supported for VPN Concentrators.