Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
935
Views
0
Helpful
1
Replies

VPN through Cisco router 7206 and 2610

rakesh
Level 1
Level 1

‎08-25-2003 02:28 AM - edited ‎02-20-2020 10:56 PM

The VPN works ok normally but when there is a power outage at remote site and after power/communication reusmes, we can ping router on remote site but not server which sends traffic though VPN to HO.

Once the server from the remote side send pings to its peer in HO, ping from HO to remote server also starts.

Can anyone suggest why does this happens?

Rakesh

0 Helpful
1 Reply 1

drolemc
Level 6
Level 6

‎09-01-2003 01:11 PM

Strange problem but it seems to be a problem with ARP rather than with the VPN setup. I think it is possible that one of the devices between your remote site server and your remote site gateway is not able to ARP properly after shutdown.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card