My VPN users are able to access IPV4 resources, but not IPV6, all of my other user who are not VPN users are able to access everything V4 and V6. Can anyone help me figure out what I have configured wrong?
However, in your case, you’re using Cisco AnyConnect. Hence, it is possible to support IPv6 through a Cisco VPN Client connection by using host-based tunnels (dynamic or static). One example of this is to leverage Intra-Site Automatic Tunnel Addressing Protocol (ISATAP) (RFC 5214) on the remote client along with an established Cisco VPN Client connection.
Remember that ISATAP is a host-based tunnel that can provide tunneled IPv6 connectivity between the host and a router, Layer 3 switch, or server. The idea is that after a Cisco VPN Client connection has been made, there should be a routing path between the host and the tunnel endpoint located inside the enterprise network. The Cisco VPN Client enables tunneled traffic through the IPv4 IPsec connection. You could refer to this URL for further details http://what-when-how.com/ipv6-for-enterprise-networks/remote-access-for-ipv6-using-cisco-vpn-client/
On February 24, 2020, the Cisco PSIRT published eleven (11) vulnerabilities in Cisco FXOS and NX-OS Software. Eight (8) out of the eleven (11) vulnerabilities were found by our internal security and engineering teams, two were found by TAC during the trou...
Hello All, i have two vm firepower as HA and they are working fine as HA the traffics going through fin but there is a red mark shows on the HA, can someone tell me what does that mean please? This only appears on the HA not in individual device...
Software Checker and Automation
This event had place on Thursday 23rd, January at 10hrs PDT
Omar Santos is an active member of the cyber security community, where he leads several industry-wide init...
Securing What's Now and What's Next. With our annual global survey of 2,800 security leaders, we dove deep to compile key benchmark statistics. The 2020 CISO Benchmark Report provides valuable takeaways and data on the most pressing cybersecurity to...
I have 2 Firepower module (ASA 5525) with Malware and IPS licence. Recently i changed the Malware policy action set to "Block Malware" and "Reset Connection". How to log the event if my policy blocked any files? Please find the attached screen shot f...