VPNClient from DOS without prompting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-14-2003 10:21 AM - edited 02-20-2020 10:51 PM
Hello,
I am using the Cisco 3.5 client to connect to a 3015 Conc.
From DOS I could run:
VPNClient Connect VpnProfile
And I get connect. But right before I get conencted I get a message:
"XYZ MainFrame access. For Authorized users only. Do you wish to Continue? y/n"
And I have to press Y to complete the VPN process.
I would like to run the VPN client through a batch file over night and every night to FTP a file to the mainframe. Is there a way to automate the "YES/Y" answer in the batch file or through a swtich key in the VPNClient command?
Thanks,
Mike
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-16-2003 09:40 PM
Already answered in VPN - Security forum.
