WAN2 Failover

[Elvis Altherr]

Hi all

I configured my ISA 550 for two WAN Ports, 1 is the main port with the IP 62.2.208.170 and the other Port (GE7) is configured as shown below as active failover

The Latency Time for the Switch over is configured to 3 seconds

the "WAN2" Port acts as DHCP Client which will be served by the second Internet Router

and finally the Link Detection is based on pinging the gateways  (for WAN2 its the Routers internal IP 192.168.1.1)

The Failover works fine, but if unplug the WAN Cable(WAN1) i can't reach the WAN2 Connection

which means on the second WAN2 Port i have no internet connection

If plug the second Router directly to the internal LAN (192.168.1.x) everything works fine

any ideas?

Thanks for your help

[Anthony.Herman]

Could you post the config please?


Sent from Cisco Technical Support Android App

[Elvis Altherr]

Hello Anthony

Thanks for your reply

Attached you'll find the file or shoud i post it directly here?

[Elvis Altherr]

Hello Anthony

Du you have receive my answer?

Any clue why it dosen't work