Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1: 07:48:59.867249 0026.51d7.65c1 0025.4538.6b73 0x0800 95: 10.235.5.31.38001 > 64.x.x.x.1194: [udp sum ok] udp 53 (DF) (ttl 62, id 0)I'm troubleshooting an issue with a device that once installed is per their support supposed to create a tunnel ove...
A client is in the beginning stages of considering a network overhaul. The design would include a central hub with roughly 50 spoke locations. The traffic at the spoke locations would be /very/ minimal. Think 1-2 endpoints at each spoke. Ideally ever...
Ok, so I had a scenario last night with NAT. I am going to post two configs, the first one is using static NAT and the second is using auto NAT. I'll just post the relevant portion. Can someone explain to me why the static NAT was not forwarding traf...
See config below.Background: Originally I had this set up without the route-map Nonat1 on the ip nat inside statements. With this if I VPNed in to the network and tried to use one of the services that were translated they would not work becuase I wou...
I have a lotus domino server running inside the network. When I connect with my IPSEC VPN I can't telnet to the internal address. Because I have a nat rule set up on the outside I can still telnet to the external IP with telnet x.x.x.x 1352 and get c...
Thanks for the replies guys. You are correct those are packet sizes and those are the ports. It turns out the device firmware was the cause of the issue.That capture was from a packet capture on 8.2 ASA. I didn't understand what the '53' was showing ...
Even though the original client is EOL it still works with win 7 and 8. I see it in production on a daily basis. In fact for some it is preferable over Anyconnect as it does not require a license.The downside is that it does not support IKEv2.Sent fr...
