WCCP - where to configure " Router Identifier:"

[chandru1989]

When i put  "show wccp 90" am getting following output. But in actual configuration, i have normal wccp configs like redirect list, web-cache group, interface, service declaration.

Could someone tell where to configure this router identifier ???

sh wccp 90 

Global WCCP information:
    Router information:
        Router Identifier:                   x.x.x.x
        Protocol Version:                    2.0

    Service Identifier: 90
        Number of Cache Engines:             6
        Number of routers:                   1
        Total Packets Redirected:            3034617706
        Redirect access-list:                wccp_redirect
        Total Connections Denied Redirect:   298

When i put  "show wccp 90" am getting following output. But in actual configuration, i have normal wccp configs like redirect list, web-cache group, interface, service declaration.

Could someone tell where to configure this router identifier ???

sh wccp 90 

Global WCCP information:
    Router information:
        Router Identifier:                   x.x.x.x
        Protocol Version:                    2.0

    Service Identifier: 90
        Number of Cache Engines:             6
        Number of routers:                   1
        Total Packets Redirected:            3034617706
        Redirect access-list:                wccp_redirect
        Total Connections Denied Redirect:   298

[Kanwaljeet Singh]

Hi,

Which device is this? Also, router id is the highest loopback ip address of the router or highest physical IP of the router  on which wccp is configured and this is chosen automatically. In newer versions there is an option to configure the RID. Please have a look below:

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipapp/configuration/xe-3sg/iap-xe-3sg-book/iap-wccp-cfg-rtr-id.html#GUID-48C7C356-B8ED-46EE-99B7-63D11F906CCA

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipapp/configuration/15-sy/iap-15-sy-book/iap-wccp-cfg-rtr-id.html

Whatever device you are configuring WCCP on, just check if you have the option to configure the router ID.

Regards,

Kanwal

Note: Please mark answers if they are helpful.