Network Security

Hi  Team, i have  upgraded  my  Cisco  ASA 5510  firewall  IOS  8.2  to  8.4  .The   command  lines  are  different  from  pre 8.4.please  help  me  to  have  a  command  of   Nat (dmz) 0  122.168.191.76 255.255.255.252 in   ASA  8.4 IOS. Regards,Sar...

hey folks,i am in progress of upgrading pix to asa and this command line is so different to understand can anybody help me with this command line  Version  6.3 PIX============1.1.1.1 OUTSIDE PUBLIC IP ADDRESS192.168.1.0 INSIDE LOCAL ADDRESS static (i...

I have 2 internet feeds, I call them Internet-WAN1 and Internet-WAN2I also have 2 VLANs, VLAN-A and VLAN-B With 1 ASA5515, how do I set up so that clients in VLAN-A can access internet via WAN1 only ? And the same for VLAN-B to WAN2 ?I'm familiar wit...

Hello,This is my first time working with the X genertaion of firewalls.  I note from an output of show interface ip brief I get an additional 4 interfaces along with the gigabitethernet interfaces, namely: Internal-Control0/0        127.0.1.1       Y...

I made a small prod network with 3 internal segments and the outside interface.  I am routing entirely on the ASA 5525xI should have done the routing on L3 switches at a minimum, but I'm trying to see if I can stopgap the pain by disabling traffic in...

Hi guys,I have one ASA 5505 running 8.4(2) with two interfaces:5505# show ipSystem IP Addresses:Interface                Name                   IP address      Subnet mask     Method Vlan2                    outside                80.82.x.y    255.25...

I have ASA 5512 configured like below:g0/0 : outside --->  security 0, connect to the internet via GW router, private IP /30, no NAT (NAT is occur on the GW router)g0/1 : inside1 ---> security 100, connect directly to LAN 10.x.x.xg0/2 : inside2 ---->...

HI,I really need help with this  and I read on a lot of forums.static (Inside,DMZ) 192.168.21.0 192.168.21.0 netmask 255.255.255.0I am not sure how to that in 9.1.I looked everywhere, but no luck.Alsostatic (Inside,Outside) tcp interface 2326 192.168...

HI Guys , I have a problem in converting the static nat in fwsm to ASA 8.3 or later.I have a fwsm which we are migrating to ASA, FWSM has a below static nat statement, static (v123,v546) 10.10.10.0 10.10.20.0 netmask 255.255.255.0When I see the trans...

Hi All, I have a scenario as follows, clients ---- ASA ---- Internet                 |  DMZ interface              Web Proxy My clients on the inside needs to get redirected to a web proxy server which is behind the DMZ interface. Now WCCP works fine...

I have ASA5525-X and I can't save configuration because of flash memory doesn't let me. I tried to format from rommon but results are same. Is there someone who can help me to fix a problem?