If the no service password-recovery command has been configured on a router, the break sequence will no longer work in order to get to ROM Monitor (ROMmon) mode to perform a password recovery. If this feature is enabled, the following message is displayed at bootup, indicating that the password recovery functionality is disabled.
System Bootstrap, Version 11.1(4675) [kluk 143], INTERIM SOFTWARE
Copyright (c) 1994-1996 by cisco Systems, Inc.
C3600 processor with 32768 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
PASSWORD RECOVERY FUNCTIONALITY IS DISABLED
program load complete, entry point: 0x80008000, size: 0x2733f4
Recovery from this state is possible. However, the startup configuration in NVRAM will be lost.
If a Cisco 1700, 2600, 3600, or 3700 series router has been configured with the no service password-recovery command and the enable password is not known, perform the following steps in order to recover the password:
Boot the system.
After the Cisco IOS image decompresses and shows [OK] (as in the example shown), enter a break sequence within five seconds.
The router then asks if you want to reset it to the factory default configuration with the following message:
PASSWORD RECOVERY IS DISABLED.
Do you want to reset the router to factory default
configuration and proceed [y/n] ? y
Reset router configuration to factory default.
The router now boots with no configuration.
If the no service password-recovery command is enabled and no valid Cisco IOS image is in Flash, then the above procedure does not work. If this is the case, a Flash already containing a valid Cisco IOS image must be installed first and then the procedure above may be performed. This is because the xmodem and tftpdnld commands are not available due to the inability to access ROMmon.
On the Cisco 3640 and 3660 routers only, the NVRAM chip may be removed and reinstalled in order to erase the configuration. This is possible on these models because a separate battery holds the configuration, and when the chip is removed, the configuration is lost. The silkscreen on the motherboard will identify it as "NVRAM". Be sure to use proper anti-static procedures when handling NVRAM. This procedure does not work on the Cisco 1700, 2600, or 3620 models and should be done only as a last resort if no Cisco IOS image is present in Flash.
Thank you to all who have posted and responded to all of the TDR questions over the past which i have reviewed.
I could not find thru many searches any mention of what Cisco PAIR A,B, & map to...
I would like to know if anyone can ...
Could you please help, after this configuration, many users couldn't have connection Note:I have 2 switches in cascade, and I did the same config on both switches -------- Config ----------------------Access-Switch(config)#ip dhcp snooping ...
Hello All, on our Cisco 3650 switches I can easly and continiously write the syslog to the local flash file system with the command "logging file flash:systemlog 409600 informational". But this does not work on an ASR 1001-X router. How can I co...
Hello,We made some changes in our Database and i need to configure two layer 3 switchs working in redundancy for two differents site.If the first switch lose the internet connection the second gonna take the rule and allow all the users go the intern...
Good morning all! I'm running into an issue with some OSPF inter-area routing I'm working on. In a nutshell, I have a core switch and a WAN device in area 0 and the same core switch and a Fortigate in area 2. All WAN routes are learned in area 0 and being...