Cisco Community
English
Register
ANNOUNCEMENT - Upcoming Changes in the email address of Community email notifications - LEARN MORE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco SD-Access: Embedded wireless on Catalyst 9300 Deployment Guide (1.2.10)

2196
Views
0
Helpful
1
Comments
kangupta
Cisco Employee
‎07-08-2019 02:46 PM
edited on: ‎07-08-2019 ‎02:46 PM

 

0 Helpful
Comments
ciscoid3890
Beginner
Beginner
‎01-16-2020 02:14 AM
‎01-16-2020 02:14 AM

Hi, is there also an upgrade procedure for embedded WLC on border/CP (in DNAC)?

 

Regards,

Wim

Latest Contents
How can i configure QoS for solve this problem?
Created by eduardomora473 on 07-05-2020 08:06 AM
0
0
0
0
Hello everyone, i am studying QoS for solve a problem in the enterprise that i work. I read that first i need to mark the traffic the most close of the origin so next what? should i go to the other nodes and configure the policies based on the marks. For ... view more
non-full routing aggregation problem
Created by Steve Zhou on 07-05-2020 06:54 AM
1
0
1
0
Hi,When I was calculating aggregating routes for (192.168.0.0/24 ~ 192.168.7.0/24), a quick question jumped into my head was what about 192.168.8.0/24? It is a valid subnet, but it's not part of 192.168.0.0/21. What if I did't have the next 8 subnets bloc... view more
2960 QoS policy
Created by warendondon on 07-05-2020 06:21 AM
0
0
0
0
Hi, We have to configure QoS on 2960 LAN Base switch for Voice, considering https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_53_se/configuration/guide/2960scg/swqos.html#20651 We set DSCP from Voice devices, ... view more
DHCP Snooping and IP Source Guard
Created by medharrak on 07-05-2020 06:07 AM
0
0
0
0
Hi,I'm trying to configure DHCP snooping with IP Source Guard.My topology (attached ) contained 3 Switches , where I created 2 VLANs 100 and 200.the network wroks fine I can reach pc on the same VLAN from an AS-1 to AS-2, However when I enable "IP Source ... view more
Express Setup / Factory default / Catalyst 3560-cx PD
Created by Tim Schenk on 07-05-2020 04:46 AM
0
0
0
0
Hello everybody I have two questions regarding1. Express SetupHow can I activate the Express Setup on the switch?Manual:Accessing the CLI Through Express Setup..."Set the switch in Express Setup mode..."In the manual I do not find further information... view more
CreatePlease to create content
Discussion
Blog
Document
Video
Content for Community-Ad
Cisco Community May 2020 Spotlight Award Winners
Follow our Social Media Channels