Borders are the entry and exit point for the Fabric, there are different types based on what type of network domain they are connecting to. Cisco DNA Center allows you to configure Border options in Provision > Fabric.
In Cisco DNAC 1.2, there were following Border options to be configured for SD-Access fabric:
Internal Border (a Border that connects to known IP prefixes/ Rest of Company)
External Border (a Border that connects to unknown prefixes/Outside World)
Internal + External Border (a Border that connects to unknown and known prefixes/Anywhere).
In Cisco DNAC 1.3, there is only one "Border Node" selection. Within the "Border Node" configuration, different selections have to be made to make the border: Internal only, External only, or Internal+External.
To configure border as an Internal only, External only or Internal+External do the following:
Initially without any configuration, a border is an "Internal" border.
To configure Border as "External" border, check "Default to all Virtual Networks" and "Do not import external routes"
To configure Border as "Internal + External" border, check "Default to all Virtual Networks" and uncheck "Do not import external routes".
"Connected to internet" option is only applicable in the case of "SD-Access Transit".
The mapping between old options and the new is as below:
Hi, I am struggling with the setup of the WLC 9800 on a Catalyst 9300 Switch. I would like to configure it from DNA Center but I think DNA Center is not aware that I have one.Here is the output from my switch Next reload AIR license Level: AIR DNA Ad...
Hi all, I’ve been reading up and SPAN and the use of aggregator taps and full duplex taps. I feel i have a better understanding of each, but i still have a question that cannot seem find the answer to, hopefully somebody will know the answer to...
Dear All , I am doing my thesis on Segment Routing and trying to show the benefits of SR by using GNS3 and building a network and implementing SR and testing some use cases I'd need your help and suggestions the network is as shown below &n...
Hi All and thanks for any clues or solutions. First Issue My VPN setup seems to work ( Connects fine to my Iphone and Ipad) even with some issues in the log !! ?? Should I just ignore those ?? %CRYPTO-6-IKMP_MODE_FAILUR...
Hi, I'm testing a dual cloud dmvpn as a backup for mpls. Dmvpn using ibgp and mpls using ebgp between hub and spokes. Each Cloud has single hub and these two hubs sharing same DC LAN Network subnet and using eigrp in DC.Each huB has one mpls li...