The card in a fixed hardware configuration Cat chassis functions improperly, not online.
Problems occur when either the system status LEDs indicate a problem, the ports are not recognized or show faulty status, or when users are experiencing poor performance. The LED status on each port indicates whether the ports are functioning correctly. Some fixed hardware configuration chassis support modular Gigabit Interface Converters (GBICs). If these ports are improperly installed in the switch, it does not function.
To resolve fixed hardware configuration Catalyst chassis issues, perform these steps:
Capture the output of the show version command.
Determine if the software version you are running supports this module. Refer to the Cisco IOS Software section of the Software Advisor for assistance. For Catalyst OS (CatOS), refer to the CatOS Supported Hardware section.
Determine if the status is faulty for that port (port LED) or the chassis itself (system LED).
Remove any GBIC ports and inspect them for bent pins.
Reseat the GBIC ports carefully. If the port status is still faulty, try them in another port.
In some cases, a badly-seated GBIC can cause symptoms that appear to be a hardware failure. It may cause traffic corruption on the backplane, which might result in various problems occurring in the Catalyst chassis. Reseating all the GBICs can resolve this and allow the self tests to pass.
To display information about the currently loaded software along with hardware and device information, use the show version command in user EXEC, privileged EXEC, or diagnostic mode.
Cisco ASR 1000 Series Routers
show version [rp-slot] [installed [user-interface] | provisioned | running]
Cisco Catalyst 6500 Series Routers
show version [epld slot]
Specifies the software of the RP in a specific RP slot of a Cisco ASR 1000 Series Router. Options include:
•r0—the RP in RP slot 0.
•r1—the RP in RP slot 1.
•rp active—the active RP.
•rp standby—the standby RP.
Specifies information on the software installed on the RP
Specifies information on the files related to the user-interface.
Specifies information on the software files that are provisioned.
Specifies information on the files currently running.
(Optional) Specifies the software of the EPLD slot of a Cisco Catalyst 6500 Series Router.
How a switch can recognize traffic as “video” and what knobs inside a switch are available for a network designer to achieve this requirement???There are Media net on the switch that can automatically detect the device type connected to the...
Hi all. For a couple of years I've had two Cisco 1941 routers running IOS and BVI interfaces to support some end user devices. I have two Cisco ISR4321 running IOS-XE which from what I've read you must do BDI interfaces. I attached a diagram and applicabl...
Dear all,Now I have been investigating whether Cat65-MSFC can configureNetFlow NAT record or not. For instance other vendor such as FortiGate can support so I think Cisco might support for this.https://docs.fortinet.com/document/fortigate/6.0.6/handb...
Hello, I have to change a Cisco 3845 and install a Cisco ISR 4451. The problem is I have a subinterface with 30 helper-address: When I insert more than 16 directions using helper-address command, I have an error message which says that the router does not...
I have some closet with relatively old 6509s that I am trying to configure for 802.1x and MAB. For my test case, I am using a Cisco AP which is getting profiled from ISE and added to the MAB group. ISE shows the authentication passing and return...