The %PLATFORM_CAT3550-1-CRASHED: [chars] error message means that the system attempts to display the crash message from the previous crash. [chars] is the crash message.
A Cisco Catalyst Switch that runs Cisco IOS Software Release 12.1(19)EA1x, 12.1(20)EA1x, 12.1(20)EA2, 12.1(22)EA1, 12.2(25)SG, 12.2(25)SEA, 12.2(25)SEB, 12.2(25)EZ, or 12.2(25)EY can reload when the show cdp neighbors detail command is issued. This defect does not affect any other Cisco IOS software releases.
This problem occurs when the Cisco Discovery Protocol (CDP) neighbor is removed exactly when the show cdp neighbors detail command is issued. This problem occurs only when a show cdp command must display the management IP address of the CDP neighbor. The problem does not occur if the show cdp neighbors command is executed without the detail option. For example, this problem can occur if the show cdp neighbor FastEthernet0/1 detail command is issued, but does not occur not when the show cdp neighbor FastEthernet0/1 command is issued.
This problem can also occur if the show cdp entry * command is issued, because this command displays the IP address of the CDP neighbor.
These Cisco bug IDs identify and document this problem:
In order to resolve this problem, upgrade the Cisco IOS Software on the switch to either Cisco IOS Software Release 12.1(22)EA2,12.2(25)EY1, 12.2(25)SEB1, 12.2(25)SEC or to the latest maintenance release, which is available for download on Cisco Downloads.
Hello, I have two access points, but they are connected to a computer:AP1 192.168.66.6 (the ipaddr of the computer interface is 192.168.66.1)AP2 192.168.67.6 (the ipaddr of the computer interface is 192.168.67.1)The computer's ip "itself" is 192.168....
Do you know if any outage is expected when changing LACP rate from slow to fast?Any experience or information would be appreciated.Also please advise if there's any test environment lab to check this kind of configurations.
Hello Cisco community, I have an issue with IOS upgrade for WS-C2960X-24PS-L in the stack.After the reload , switch still boot up with the original IOS 15.2(6)E2 , not with requested IOS c2960x-universalk9-mz.152-7.E3.bin&n...
HelloAs my Switch and ASA running-config's both show, my system is all working completely.What it does not show is that the vlan 10 and vlan 11 IP's (10.0.1.161 and 10.0.2.124)are getting their IP's from 2 separate Routers, TPLink and D-Link.The TPLink is...
please help in using OSPF in intervlan network and DHCP? Ur guidance will be highly appreciable i applied VLANs and they are working fine, however i need to add OSPF and DHCP and more MLS and extend network in it, what would be configuration for it?