The Incorrect trunk type specified for port error message is received when the set trunknegotiate command is issued to configure the type of trunk encapsulation.
When the set trunknegotiate command is issued and the module of the switch supports only one type of trunk encapsulation (either ISL or 802.1Q), the error message will be dispalyed. Because the switch cannot form the trunk by negotiating if the trunk encapsulation is configured differently in other end of the switch.
All Cisco Catalyst ports do not support 802.1Q encapsulation. Currently, Cisco Catalyst 4500/4000 switches support only 802.1Q. Ports of the Cisco Catalyst 6500/6000 families are able to use 802.1Q or ISL encapsulation. Depending on the module, Catalyst 5500/5000 trunk-capable ports are able to use 802.1Q encapsulation, ISL encapsulation, or both.
To verify the trunk encapsulation type, issue the show port capabilities command. Issue the set trunknegotiate command only if the port supports both the encapsulation type.
The trunk capacity is explicitly stated as in the output:
Switch> (enable) show port capabilities 1/1 Model WS-X5530 Port 1/1 Type 1000BaseSX Speed 1000 Duplex full Trunk encap type 802.1Q,ISL Trunk mode on,off,desirable,auto,nonegotiate Channel no Broadcast suppression percentage(0-100) Flow control receive-(off,on,desired),send-(off,on,desired) Security no Membership static Fast start yes Rewrite no
Hello Cisco community
Purchased single Catalyst Switch C3750G-WS24-S25 with integrated wireless controller. Had to do password reset, and by mistake deleted some files and folders from flash: while being in rommon mode. Also wanted to shorten boot ...
Hi,I've got below topology with RTA internally peered with RR1 and RR2 as client. RR1 and RR2 are normal iBGP peers.I can see from RR1 the prefix received from RTA is as per below with RR1# show ip bgp ipv4 unicast nei 188.8.131.52 received-routesNe...
Hi alli know that switches have igmp enabled by default, what happens to multicast traffic when this is the case? Is it flooded to all ports or not?what happens in the case of no pim router on querier? Do they drop or forward still ?cheers
often we are receiving the STP change logs from the L2 switch and we could see flap in uplinks. We are getting log below. %SFF8472-3-THRESHOLD_VIOLATION: Gi1/1/1: Rx power low warning; Operating value: -18.2 dBm, Threshold value: -...
Hi All, I've the project to create the internet link for the critical application , The requirement is have 3 ISP redundant following with the below picture.- In normal situation the the traffic from PRD will connect internet with route1- If rou...